This is the description of JA57 XPS Shower Tray
 
If you know wedi shower system, then you must know our floor level tilable shower tray.
 
The tileable shower tray is a low-cost, easy-to-install waterproof base. There is no other wetroom tray on the market that is as easy to install as the JIT shower tray.Our shower tray can be easily to install for waterproof, used in the design of a wetroom for the home and suitable to be fixed to both timer and concrete floor. The shower tray is easily cut into any size or shape and forms a floor level, barrier-free panel ready to receive tiles with a preformed slope to the drain.
 
Application

Shower Tray System components

①Shower tray
②Floor drain body
③Ferrule
④Sealing washer
⑤Thread screws
⑥Insertring
⑦Top piece with stainless steel rim
⑧The ring of hight adjustment
⑨40mm/50mm connectoin pipe
⑩115*115mm Stainless steelGrate
⑪Drain basket
 

 

Installation Information For Wooden Framework JIT JA57 Shower Tray

Tips:
In principle, you can use all types and sizes of tiles, special requirements for tiles and
mosaic thickness to be <25mm, and the size of the tiles and mosaic on the shower tray
must be ≥50 * 50mm. Otherwise, you should consult the manufacturer.

  1. Place the shower tray in designed position and mark a circle along the hole of drain body. Cut out a shape on the floor to install the shower tray.
   2. Measure and mark where your drain and waste pipe will be fitted.Cutting drain shape out of plywood for waste,this should be 10mm higher than drain body.Connecting the drain body to the waste pipe with solvent weld in the usual way.(Always check for leaks before final installation of shower tray).
   3. Once you are satisfied with the drainage,replace the plywood section around the drain and fix all floor infills in position.
   4. Re-pave the board and reserve a hole for shower drain.Spread adhesive evenly over the floor with toothed scraper, place the shower tray onto the floor in correct position.
   5. After installation is completed, level it with the gradienter (ensure the shower tray is horizontal).
   6. And then do some waterproofing treatments on the gap of boards with waterproof coating.
   7. After the waterproofing treatment is completed, do the tile paving (Note: appropriate tile height ≤ 10mm, If the tiles height ≥ 10mm, please balance the height by riser piece which enclosed).
   8. And then, install the other drain accessories on the drain body.
   9. The shower base is finished and canbe tiled.

Installation Information For Concrete Floor JIT JA57 Shower Tray

①Screed
②JIT waterproof sealing tape
③20/25/30/40mm shower tray
④Slope
⑤JA57 floor drain
⑥Levelling screed
⑦Concrete floor
 

 Position:                                                    Normal Position:                                     Normal Position:

Centre drain A=1/2 length B=1/2 width     Offset drain A=450mm B=1/2 width          Corner drain A=B=260mm

 

Related Products

JA74LV Linear Drain Floor Level Tileable Shower Pan

JA70 Linear Drain Shower Tray

JA74L Floor Level Linear Shower Tray

JA79 Pre-sloped Shower Base

Just say hello and leave your messages