This is the description of JA74L Floor Level Linear Shower Tray
 
If you know wedi shower system, then you must know our floor level tilable shower tray.
 
The tileable shower tray is a low-cost, easy-to-install waterproof base. There is no other wetroom tray on the market that is as easy to install as the JIT shower tray.Our shower tray can be easily to install for waterproof, used in the design of a wetroom for the home and suitable to be fixed to both timer and concrete floor. The shower tray is easily cut into any size or shape and forms a floor level, barrier-free panel ready to receive tiles with a preformed slope to the drain.
 
 Application
Shower Tray System components

1.Drain Body
2.Dip-tube .
3.O-Ring .
4.Drain Basket .
5.50-40mm Reducer .
6 Height Adjustment Shim ( thickness1.5mm ) .
7A Screw For Connection ( M6*29 ) .
7B Short Or Long Screw For Height Adjustment Shim
(Please use these screws according to your requirement)
8.Connection
9.Plastic support 300/600/800mm length
10A Stainless Steel Support 300/600/800mm length 
10B Stainless Steel Grate 300/600/800mm length

 

 

Installation Information For JIT JA74L Linear Shower Tray

Tips:
In principle, you can use all types and sizes of tiles, special requirements for tiles and
mosaic thickness to be <25mm, and the size of the tiles and mosaic on the shower tray
must be ≥50 * 50mm. Otherwise, you should consult the manufacturer.

  1.Place the shower tray in designed position and mark a circle
along the hole of drain body. Cut out a shape on the floor to install
the shower tray.
  2.Coated with glue on drain body and connect with water pipe.
  3.Measure and mark where your drain and waste pipe will be fitted
. Cutting drain shape out of plywood for waste .Connecting the
drain body to the waste pipe with solvent weld in the usual way .
(Always check for leaks before final installation of shower tray).
  4.Apply the screws for connection onto the backside of shower tray.
  5.After the levelling screed has hardened, an appropriate
adhesive(e.g.tile adhesive/flexible glue) is applied all over the underside of the shower tray with a notched scraper.
  6.Use a gradienter to make sure that the shower tray is level after it was installed onto floor. Then put some weights onto the four corners and centre of shower tray in order to firm it.

  7.Seal all joints (both wall and floor) by JIT special waterproof paint.
  8A.When grate is not tile on grate, adjust the height of stainless steel .
suppot by height adjustment shims, each shim can increase 1.5mm.
Choose short or long screw according to the total height of shims to fix the stainless steel support onto the plastic support of shower tray.
  8B.When use tile on grate, the height of stainless steel support can be .
adjusted by height adjustment shims, but the inner height of tile on
grate(13mm) is fixed, so please judge whether the same thickness of tiles should be used for the tile on grate or for the shower tray.
  9.Installation of shower tray is completed , can do tiling now.

 

Related Products

JA79 Pre-sloped Shower Base

JA70 Linear Drain Shower Tray

JA74 Pre-sloped Shower Tray

JA74LV Linear Drain Floor Level Tileable Shower Pan

Just say hello and leave your messages