This is the description of JA79 Pre-sloped Shower Base
 
If you know wedi shower system, then you must know our floor level tileable shower base.
 
The tileable shower base is a low-cost, easy-to-install waterproof base. There is no other wetroom base on the market that is as easy to install as the JIT shower base.Our shower base can be easily to install for waterproof, used in the design of a wetroom for the home and suitable to be fixed to both timer and concrete floor. The shower base is easily cut into any size or shape and forms a floor level, barrier-free panel ready to receive tiles with a preformed slope to the drain.

Application

Shower Base System components

1.Shower base
2a.Drain body
2b.40mm/50mm connectoin pipe
3a.Key
3b.Dip-tube
3c.Drain connector
4.O-ring
5.Sealing rubber
6.plastic Piece
7.Riser Piece
8.Great

 

Installation Information For Wooden Framework JIT JA79 Shower Base

Tips:
In principle, you can use all types and sizes of tiles, special requirements for tiles and
mosaic thickness to be <25mm, and the size of the tiles and mosaic on the shower base
must be ≥50 * 50mm. Otherwise, you should consult the manufacturer.

1. Put shower base in right position and mark a circle along the hole of drain body.

 2. Cut and move the floor board to accept the shower tray and drain.

 3. Measure and mark where your drain and waste
pipe will be fitted.Cut drain shape out of plywood
for waste,this should be 10mm higher than drain
body.Connect the drain body to the waste pipe
with solvent weld in the usual way.(Always check
for leaks before final installation of shower tray).

 4. Fix a batten below the top of the joists.

5.Once you are satisfied with the
drainage,replace the plywood section around the
drain and fix all floor infills in position.

6.Spread the adhesive evenly over the area
where the shower base is to be installed,being
carefully to clean away any adhesive on the rim
of the trap.

7.Level measurement of the surface is smooth.

 8. Put the O-ring into the groove of plastic support.

 9. Fix the drain connector into the drain body with a key fixed.

10.Seal all joints(both wall and floor) by JIT special waterproof paint.

11.Seal all corners of shower area by JIT waterproof tape.

12.The shower tray is finished and can be tiled.

Installation Information For Concrete Floor JIT JA79 Shower Base

①Screed
②JIT waterproof sealing tape
③20/25/30/40mm shower base
④Slope
⑤JA57 floor drain
⑥Levelling screed
⑦Concrete floor
 

 Position:                                                    Normal Position:                                      Normal Position:

Centre drain A=1/2 length B=1/2 width     Offset drain A=450mm B=1/2 width          Corner drain A=B=260mm

 

 

Related Products

JA74LV Linear Drain Floor Level Tileable Shower Pan

JA74L Floor Level Linear Shower Tray

JA57 XPS Shower Tray

JA99 Floor Level Tileable Shower Pan

Just say hello and leave your messages